Vehicle & Technical > Defender

Home made TD5 wading kit and Mantec Snorkel

<< < (2/2)

Porny:

--- Quote from: "SteveG" ---

Good point Ian and it's less likely to be pulled out that way too! - I just used what was available from local farm supplies place.

Cheers

Steve
--- End quote ---


I can get hold of some if required from my local pneumatics dealer.



ECU wise, I'm sure Tim Burt will correct me if I'm wrong....

But I'm sure all Devon 4x4 have done is re-routed the wires up through the top of the seatbox so that the ECU is bolted to the bulkhead.  Means it's higher than standard.  (they've also done this as they've fitted an underseat tank).  Have also moved the fuse box at the same time.

See here: http://www.devon4x4.com/gallery/photos/Challenge_90_Build/5/02cdf9df21d7161e26a464985312977b.jpg/

And: http://www.devon4x4.com/gallery/photos/Challenge_90_Build/6/81a71cd23bfbfd8283440b988899bc03.jpg/

This mod would cost nothing other than a bit of time :wink:

But probably a bit difficult for you BTM... as you haven't got a rear bulkhead!!!

Other option as mentioned is to fit the ECU into a sealed box - with a breather.



Ian

Navigation

[0] Message Index

[*] Previous page