Vehicle & Technical > Discovery

I've been busy today

<< < (2/3) > >>

beast5680:

--- Quote from: "blackbob" ---wots a viscus spanner



i use a 30cm long chissel :lol:  :lol:
--- End quote ---


 :lol: i,m glad its not just me then

bezzabsa:

--- Quote from: "RedlineMike" ---
--- Quote from: "bezzabsa" ---why remove the fan? surely with the shroud removed theres plenty of room to get to rad ???
--- End quote ---

you need to remove the fan to get the shroud out  :wink:
--- End quote ---

stanley knife? refit with cable ties :D:D:D:D:D

Xtremeteam:

--- Quote from: "bezzabsa" ---
--- Quote from: "RedlineMike" ---
--- Quote from: "bezzabsa" ---why remove the fan? surely with the shroud removed theres plenty of room to get to rad ???
--- End quote ---

you need to remove the fan to get the shroud out  :wink:
--- End quote ---

stanley knife? refit with cable ties :D:D:D:D:D
--- End quote ---


rough as a badgers arse  :lol:  :lol:

wheres the attention to detail  :lol:  :lol:

dave_2A_2.25Turbo:
I've changed the rad in loads of discos (200/300s) and never taken the fan off yet.

If you unbolt the shroud and move it back towards the engine (turning it through 90 degrees), there's room to get the rad out.

Jake:
I took mine out because Mr Haynes said i should as to not damage the new one.
Worked for me and it only took 2 secs to remove the fan.
Each to their own.
 :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page