Chat & Social > The Bar - General Chat

welding - 1st attempt

<< < (2/3) > >>

skip:
To weld thin metal on an edge like that is quite an undertaking with a arc welder, Well done! specially for a first attempt, it takes a while to get a steady hand :) . When I first started it looked more like pidgeon s**t  than weld :lol:

Snooky:
Someone has just donated a welder to me, and hope my 1st attempt looks as good as that one, but some how I doubt it.
Won't be putting up my 1st attempt thats for sure  :wink:

Range Rover Blues:
Well practice makes perfect and remeber that the weldig is done by current, so nice clean surfaces everyone :wink:

AbyssDJ:
i could do with getting a welder and learning how to use it... thers alsorts of things id like to make with one

tomcat:

--- Quote from: "landyloony" ---I think I've found out now why the old seat was sagging so much  :shock:
--- End quote ---


that seat needs to go in a skip mate,once they brake like that all the strength has been lost,just thinkig of ya safty.i have seen a few seats come apart after a crash that have been repaired "its not nice"
                     
                               john t :|  8-[

Navigation

[0] Message Index

[#] Next page

[*] Previous page