Vehicle & Technical > Defender

defender bonnet scoops - BOB696 & CO

<< < (2/3) > >>

dreadnought110:
:D It fit's nice as well,it sits well on the bonnet you have to cut out the front for your own holes i did it by using a hole saw did 2 holes about 3" between them then cut between, did 3 like this to get the effect i have put mesh behind it as well! 8)

Litch:
The only problem I can see that if you are wading (fully prepared with rad temp blocked off etc) and the water goes over the top of the bonnet (as it quite often does) then it will be channelled along the bonnet (the shape of which is perfect for this), in through the scoop and straight onto the back of the engine, bulkhead etc.
Problem?

dreadnought110:
:) No worse than what comes from the fan up etc.. you could always sort out a flap to block it off, mind you with land rover panel fit you get as much under the edge's of the bonnet i have been deep wading and not had a problem?? :lol:

jjsaul:
probably only a problem for those of us with V8's   :lol:

AbyssDJ:
you said it puddle boy :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page