Vehicle & Technical > Isuzu / Frontera

I thought I had better ask before I break something....

<< < (2/2)

dreadnought110:
:D I couldn't get mine of and i couldn't wedge it tight enough, so borrowed me mates brakedown van with compressor on it 1" airgun did it instantly!!

Jas278:
If you can get in ,put a socket and bar on the nut , wedge it under the chassis ,then crank the engine (turn the key), this usually works , be careful it does nt spit the bar out ............

Manicminer:
It came off eventually :roll: (with the help of a scaffold pole)
The problem now it's bucketing it down and I can't be bothered getting wet :roll:

I needed to take the pulley off to get the timing belt cover off to change the water pump. Since it's off I might as well change the timing belt.

Sod it, I shall use my car for going to work tomorrow.

snezza69:
Sounds like you earned yourself a beer!

karloss:

--- Quote from: "Jas278" ---If you can get in ,put a socket and bar on the nut , wedge it under the chassis ,then crank the engine (turn the key), this usually works , be careful it does nt spit the bar out ............
--- End quote ---


For gods sake disconect something to stop it starting if your going down this route. It works every time but it's not something you want going wrong!!!!

Navigation

[0] Message Index

[*] Previous page