Vehicle & Technical > Discovery
Anti roll bars (updated with new fitted parts from D4x4)
Cal:
yeah you do need to modify them a bit - use a round file to make the hole in the top plate into a slot otherwise you wont be able to fit the bolt in to bolt the two bits of the cone together. Or you can cut away some of the lip of the bodywork - I did a bit of both...
Very hard to explain but you will see what I mean when you try and fit them! :D
Porny:
Or get a set from QT :wink:
no mods needed :D :wink:
Axle mounted so springs re-seat with no noise.
Cal:
Nice! The more I see of your truck Porny, the more I like it!! 8)
Steve ray:
Has anyone expereinced any trouble at MOT time by removing the anti-roll bars?
Mace:
This topic has been done several times before. If you remove the anti-roll bars then it will NOT fail the mot. If the anti-roll bars are fitted then they will be tested by the mot and subsequently pass or fail.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version