Chat & Social > The Bar - General Chat
Hydraulic stuff
Jimbo:
--- Quote from: "paul_humphreys" ---Just a point to note Jim. The oil cooler on mine is not for the winch, its for the gear box to stop it over heating when using the PTO. Just make sure its for the winch before you remove it.
Paul
--- End quote ---
Paul, good point. The drawing I have shows the cooler connecting directly to the oil tank, I will (of course !) trace the hoses back before disconnecting anything - and then of course I'll need something to plug the holes in the tank :roll: Might have to have a measure up and then find a friendly Pirtek man !
Navigation
[0] Message Index
[*] Previous page
Go to full version