Chat & Social > The Bar - General Chat

air rifle rack.

(1/3) > >>

mark.yellow.series.3:
hi everyone,
iam going to make a gun rack for the series. i need it to hold two air rifles. i was thinking of two pieces of 1" angle about 2' apart, vertically joined to the rear bulkhead behind the seats upto the roof, then just a couple of u shaped brakets off each bit of angle to hold the guns.

has anyone got any other ideas?

cheers in advance.
mark

Nick666:
If you put some rubber/foam on the u-brackets that'd stop it rattling about so much while driving. Make the brackets deep enough that you could then put a pin or something through the top (over the gun) which would help hold it in over bumps.

Sounds like a good idea :)

mark.yellow.series.3:

--- Quote from: "Nick666" ---If you put some rubber/foam on the u-brackets that'd stop it rattling about so much while driving. Make the brackets deep enough that you could then put a pin or something through the top (over the gun) which would help hold it in over bumps.

Sounds like a good idea :)
--- End quote ---


good idea, i was thinking of how i was going to keep the guns from jumping out, i was thinking of a strap, but your ideas is better. i could also drill the pin so a small padlock could go through.

Andy the Landy:
I'll take some pics of my gun rack and email them over :wink:

mark.yellow.series.3:

--- Quote from: "Andy the Landy" ---I'll take some pics of my gun rack and email them over :wink:
--- End quote ---


cheers mate, did you make yours or buy it?

Navigation

[0] Message Index

[#] Next page