Vehicle & Technical > Range Rover

Ive dropped a bit of a B££$%^

(1/2) > >>

zulublue:
I have just put a 2" lift on my 82 RRC and have decided to change the disc's and pads, I removed the brake lines to put braided one on and had to change one of the pipes that runs to the master cylinder?

The clanger I dropped I did not label the pipe to know which pipe goes to which inlet as there are 2.

First of all does this matter? I hear the is a primary and secondary intake, if it does matter how do I know which one goes in what position.

Mark.

blackbob:
http://forums.mud-club.com/viewtopic.php?t=20996
was a qustion i asked earlyer this year  :lol:

zulublue:
Cheers for that, but is does not help me to much, I have the lines in place by the calliper, I just don't know if it matters which way round they go, 50/50 I suppose.

And if I get it the wrong way on one a correct on the other will it make a difference?????

Range Rover Blues:
Only when the brakes f**k up.  IIRC the Primary circuit does not include the rear callipers.

jjsaul:
i replaced all the front brake pipes (fixed and flexi)on my project...no idea what way they all went back on but the brakes work  :roll:

Navigation

[0] Message Index

[#] Next page