Vehicle & Technical > Series Land Rovers

Changing Clutch on Series 3

<< < (2/2)

sleeper88:
Glad you managed to get the cluch done.

I have just taken the floor out of my one as the release baring has colapsed due to getting muddy water over the front wings at woodlands in Kent  last week
My starter motor has also quit  its probably full of mud as well

There should be a plate over that wapping great hole in the top of the flywheeel housing and the same is true where the gear leaver mounts onto the bell housing

Dave

Topple:
Think next time I do some deep wading I'll blank off the holes with duck tape as a temporary measure.

I had similar problems with the starter motor last year, took it all apart and gave it a good clean, it's been ok since.

Paul

Navigation

[0] Message Index

[*] Previous page