Vehicle & Technical > Suzuki

Clutch??

<< < (2/2)

Paul.K/LuckyTrucker:
Hi there, I think your over heating problem has been answeard.

I think your clutch problem maybe the thrust bearing. Mud collects in the bell housing and stops it sliding up and down the input shaft. Now don't laugh but in the past I have sorted my clutch by preasure washing through the timing hole in the bell housing with the engine running. It all runs like a washing machine, there will be a whole lot of crap coming out. I ended up changing the clutch some time later but it kept me going for a while.
Best of luck with it.

zacspeed:
What's a "Punch hunt"?  8)  

Sorry, but I have to ask!

V8MoneyPit:

--- Quote from: "zacspeed" ---What's a "Punch hunt"?  8)  

Sorry, but I have to ask!
--- End quote ---


You have a punch card attached to your car and you have to locate a series of punches that will have varying degrees of difficulty to reach. The difficult ones carry higher points.

fudge:

--- Quote from: "Paul.K/LuckyTrucker" ---Hi there, I think your over heating problem has been answeard.

I think your clutch problem maybe the thrust bearing. Mud collects in the bell housing and stops it sliding up and down the input shaft. Now don't laugh but in the past I have sorted my clutch by preasure washing through the timing hole in the bell housing with the engine running. It all runs like a washing machine, there will be a whole lot of crap coming out. I ended up changing the clutch some time later but it kept me going for a while.
Best of luck with it.
--- End quote ---


I did that then silicone'd up the hole underneath..... and replaced the Timing bung!

You'll probably need to tighten the clutch cable too!

Chomp:
Hi - thanks for all the help. I will find the time this weekend to have a look at the sj and hopefully get it sorted. Is it me or do the lists of things to do just keep getting longer and longer??

Navigation

[0] Message Index

[*] Previous page