Vehicle & Technical > Range Rover

propshaft

(1/1)

p4203:
hi folks
 after blowing my rear diff yesterday  i have taken it out but noticed my prop has loads of play in it . the question i am asking will a five speed rrc rear prop fit a four speed rrc before i start attacking the five speeder and waste loads of time for nothing
 cheers guys  :D

rangerider:
Guessing here, but as transfer case & rear axle are both in the same place, it should do.

Range Rover Blues:
Are they though, the floors are different aren't they?

Tape measure anyone?

P.S I have a couple of old RRC props if yo need one.

DEANO3528:
Although the part numbers are different I can't help thinking I used the one off my old 2 dr as a stop gap on my Vogue SE at some time. Jeez my memory...

I do know that the rear prop length is the same from around 85 right through the Borg Warner years and onto the Discovery. BW front prop was different though.

p4203:
cheers guys
 will get the tape out just to be sure ,if it's the same will save a bit of time swapping the diff over as i can leave it attached to it :D

Navigation

[0] Message Index