AuthorTopic: propshaft  (Read 732 times)

0 Members and 1 Guest are viewing this topic.

Offline p4203

  • Posts: 182
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
propshaft
« on: August 20, 2006, 13:33:29 »
hi folks
 after blowing my rear diff yesterday  i have taken it out but noticed my prop has loads of play in it . the question i am asking will a five speed rrc rear prop fit a four speed rrc before i start attacking the five speeder and waste loads of time for nothing
 cheers guys  :D
s111 109" 24volt 3.3 perkins  "beasty" 1975
300tdi disco safari  1999
2door rr 3.5 efi 1979 "shed"
1961 s11 swb soon to be 300tdi'ed

Offline rangerider

  • Posts: 228
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
propshaft
« Reply #1 on: August 20, 2006, 17:52:53 »
Guessing here, but as transfer case & rear axle are both in the same place, it should do.
Hela - Disco 200TDi, Still stock for now but watch this space.......
+ 1 battlescar

I lurv the smell of mud in the mornin'

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
propshaft
« Reply #2 on: August 21, 2006, 01:41:52 »
Are they though, the floors are different aren't they?

Tape measure anyone?

P.S I have a couple of old RRC props if yo need one.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline DEANO3528

  • Posts: 427
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
propshaft
« Reply #3 on: August 21, 2006, 08:39:52 »
Although the part numbers are different I can't help thinking I used the one off my old 2 dr as a stop gap on my Vogue SE at some time. Jeez my memory...

I do know that the rear prop length is the same from around 85 right through the Borg Warner years and onto the Discovery. BW front prop was different though.
Cheers
DEANO


Offline p4203

  • Posts: 182
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
propshaft
« Reply #4 on: August 21, 2006, 09:35:14 »
cheers guys
 will get the tape out just to be sure ,if it's the same will save a bit of time swapping the diff over as i can leave it attached to it :D
s111 109" 24volt 3.3 perkins  "beasty" 1975
300tdi disco safari  1999
2door rr 3.5 efi 1979 "shed"
1961 s11 swb soon to be 300tdi'ed

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal