Vehicle & Technical > Discovery

Tin worm live's here.

(1/1)

barmiebrumie:
Well I think I found where the water was coming in  :shock: ,

Not as bad as it looks only took 2 hour's to get the old floor out  cleanded up ready for the new one & should take about the same to get the new steel welded in tomorrow night, took two of us 9 hour's on saturday (both experiecnced panel beaters) to cut out the inner & outer sill's & make new one's (nice & flat now) bring on the MOT :twisted: ,

Found a whole family of LR spider's (LARGE spiecies) living behind the side trim's, have rehomed them behind the dash for now :wink:


John.

PUX:

--- Quote from: "barmiebrumie" ---Well I think I found where the water was coming in  :shock: ,

Not as bad as it looks only took 2 hour's to get the old floor out  cleanded up ready for the new one & should take about the same to get the new steel welded in tomorrow night, took two of us 9 hour's on saturday (both experiecnced panel beaters) to cut out the inner & outer sill's & make new one's (nice & flat now) bring on the MOT :twisted: ,

Found a whole family of LR spider's (LARGE spiecies) living behind the side trim's, have rehomed them behind the dash for now :wink:


John.
--- End quote ---
wow u got aircon too u lucky sod :lol:  :lol:

barmiebrumie:
Look's better now don't you think :lol: , only took two of us 4hr's :roll: , now to get all the seat's & carpets back in as i took them out & took them to work to get them steam cleaned,



John

the loon:
did you make up the floor pan yourself  :?:
Havent seen one with out all the ridges etc before

barmiebrumie:
Made it from sheet steel, now the carpet's back down you woud never know :wink:

John.

Navigation

[0] Message Index