Vehicle & Technical > Discovery

Poly bush kits

<< < (2/2)

Range Rover Blues:

--- Quote from: "Richie_EB4" ---The front RRC radius arms a a LOT thinner than the 300 disco ones...........so you will have to modifie the bushs...38mm-45mm.
--- End quote ---


Sure about that, on an EFi Range Rover?  'cos mine aren't. :?

Xtremeteam:

--- Quote from: "defenderdan" ---
--- Quote from: "Richie_EB4" ---The front RRC radius arms a a LOT thinner than the 300 disco ones...........so you will have to modifie the bushs...38mm-45mm.
--- End quote ---


The arms should still fit though because the axle bracket is still the same size. The narrower arms use wider bushes to make up the same width fitting. As your arms are already bushed there shouldn't be any mods needed. Just remember what the arms are off if you need to rebush in future. :)
--- End quote ---


uh uh,the early disco arms have narrow bushes & narrow holes,later ones have wide arms n wide holes,the late arms will only fir in the narrow hole if u "adjust" them (no sayin how after the last round o bitching after my input to a problem)

Range Rover Blues:
S**t, something else onmy car that's non standard then, every set of rad arms I've got are the same, but my oldest car is an '88.  I thought the front and rear arms were upgraded at about the time EFi was introduced, the front arms got the 2 stage metallistic bushes to improve handling.

Navigation

[0] Message Index

[*] Previous page