Vehicle & Technical > Defender

200tdi Rebuild

<< < (2/2)

MTyrrell:
Thanks for the comments guys,

I'll replace the pump then for the cost of a new one it's not worth fiddling about trying to rebuild it, unknownmanxman has a good point the thought of laying underneath the landy striping it all down again to replace the pump doesn't appeal to me.

 I took the head to a local engine rebuilders for a light skim as some of the head bolts seamed a bit lose when i tool it off. After measuring it up turns out that it was slightly warped :(.

MTyrrell:
Just about finished putting everything back together just ran in to one little problem,, the land rover workshop manual specifies Hylogrip 2000 as a sealant between the block and ladder frame.
 I asked the local motor factor for some to which the response was "Isn't that for sticking false teeth in" :roll:.

 Can i get away using RTV here or dose it have to be Hylogrip?

Navigation

[0] Message Index

[*] Previous page