Vehicle & Technical > Discovery

head gasket nightmare

<< < (2/2)

hobbit:
Before I read the end of the text the thought that went through my mind was could the new rings have been touching a carbon ring at the top of the bore, some replacement piston rings had a step in the top ring, to allow for this, also while if i I have an engine apart and working on pistons, I try to make sure I give the bores a honing to de-glaze them, helps when you are fitting new rings

At lease you got it sorted, hope the sump gasket dont leak for you  :wink:  :lol:

mark.yellow.series.3:
a few lessons learnt then :(
bad luck.
i would change the whole set of shells.

Xtremeteam:
i aint sayin nothin  :roll:

Navigation

[0] Message Index

[*] Previous page