Vehicle & Technical > Defender

Lifting A 110

<< < (4/6) > >>

paul_humphreys:
Before and after.

I have still got the standard size on (235/85/16) but mine is a 3 speed auto with a 1.4 t/box. I am taking it for a power tune in a few weeks to get a bit more out of it.

Paul

Sharpshooter:
I have 235 85 16's on too. Mine looks to have lifted more than yours..

Im not bragging. But it seem odd, yours sits alot more level too.

I have to test mine as a class 5 on MOT. The same a s transit vans. What is yours??

Looks nice. Especially those rims. I have been given a set of the old rrc alloys. The three spoked ones. I think i will put them on with the new rubber. If they will fit. :)

Im going for some 33 12.5 16's .

Also, mines a 2.5 diesel with a 5 speed.

paul_humphreys:
I would say the front is the same as your but the back on yours is lifted a lot more. Mine is a standard car mot (class 5) bigger vans and ex-army LR110 are Class 7. You need to check the total gross weight I thing. Some LR 110s are listed wrong. But if its an ex army then its right as the gross weight is higher. Well some thig like that. There was a good thred on a forum about it, I will see if I can find it later.

I am not sure if RR alloys are rated higher enought for a 110.

Paul

Littledan:
looks good guys :D

abinitio:
Half way through lifting on of our 110's, done the back just the front to do but it will probably have to wait til the weekend :(  Then just gotta weld a couple of repairs on the rear cross member then off to see the nice testing station man :shock:

Navigation

[0] Message Index

[#] Next page

[*] Previous page