Vehicle & Technical > Series Land Rovers

series smoking

<< < (3/8) > >>

ross501:
the pump has been off and a landy place timed it after i put it on. the injectors are new ones and it did not dhang i get black smoke on hills

mark.yellow.series.3:
after the landy place timed your pump did it run alright or has it got worse?
 it might be worth altering the timing. can you see the timing line on the flat side where one of the 3 fixing nuts are. it should line up exactly where the mark is on the engine. if its not lined up then alter it. if it is lined up then you can try playing about, you wont hurt anything by doing so but do make sure you can put the pump back how it was if the fault doesnt get any better. but remember only move the pump a tiny bit at a time, theres only half a millimeter between the egine running sweet and smoke.

ross501:
i will try that at the moment it is right round to one way full advanced i believe

Canada Al:
I agree with mark , I had the same problem with a 2 1/4 . lots of smoke on tick over but none when revving . It was pump timing . A tiny turn is all it took . This was after I had the pump recon done .
I have also had the problem of the pump being as far as it will turn in the slots and not quite timed . this turned out to be the pump timing gear which had been droped in 1 tooth out . ....Al

datalas:
again, what colour is the smoke ?

Black - Usually over fueled
Blue - Burning oil (rings, valve seals etc)
White - Water, head gasket ?
Green - stop filling it up with plutonium

Navigation

[0] Message Index

[#] Next page

[*] Previous page