Vehicle & Technical > Suzuki

Progress....finally!

(1/3) > >>

Hovis:
The jeep is starting to take shape now. A while ago i cut the front and rear wings out above the wheels along the top of the indentation (above the plastic trim), with the intention of welding in a plate from the top of the arch itself to the outer wing. This was going to give a load more clearance. Well my mate decided on an 'easier' solution (see the pictures)! The extra clearance is massive, the picture with the wheel on is a little deceptive as there isn't a lot of weight on it, but its still loads at least 2".

Buckets are mounted and ready to bolt in as is the rear seat, bumper is nearly finished, all the gaskets on the top end have been done and the cam belt. Just needs the welding finished and a lick of paint and it's off to the MOTer. Woo Hoo!!!

Hovis:
And the rest..............

Littledan:
any pics mate?

Hovis:

--- Quote from: "FLATPACK!" ---any pics mate?
--- End quote ---


Can you not see the ones posted? There should be six there, i can see them.

If not, have a look at my gallery 'New 413' all the pictures are in there.

Littledan:

--- Quote from: "Hovis" ---
--- Quote from: "FLATPACK!" ---any pics mate?
--- End quote ---


Can you not see the ones posted? There should be six there, i can see them.

If not, have a look at my gallery 'New 413' all the pictures are in there.
--- End quote ---


ah sorry mate they didnt show up before but they there now looking good i must say, was it easy to weld to the wing? im half way through mine but didnt kno if it would hold?

heres mine:

Navigation

[0] Message Index

[#] Next page