Chat & Social > The Bar - General Chat
What I repaired today
Mace:
--- Quote from: "davidlandy" ---
Why u ask, are u a volvo fan?
--- End quote ---
Oooo I feel sick all of a sudden :oops:
Guy90:
The gutter above the garage door. I damaged it with your engine hoist awhile back!!
Guy
Frankie-Boy:
Hi Dave,
The remains of your bearing reminded me of the one I did on Litt-lun awhile back, that was completely shot too. :?
Make sure you clean that hub nut spanner before you lend it to me please, shocking to leave a valuable (and much needed) item in such a state. :wink:
Sooty:
Hi Dave
Welcome to the "colapsted bearing club" I have one go at the start of the year and as I removed the hub my lad Lewis sayed "all the bullets have fallen out" a pile of rollers on the floor and a bit of twisted metal in the hub!!!!
I have my own hub nut spanner too :wink:
Check the others TODAY or you will be sorry :(
Wanderer:
I stick high melting point grease in the bearings and removed the EP90 on the front and replaced it with one shot.
It seems Ok.
Looks like some water ingress in the photo Dave. Did you make sure you'd sealed the half shaft when you fitted it.
As Frankie noted. You'll be ask to leave the brotherhood if you leave the spanner in that state again.
Cleanliness is next to ....................................
Fill in your own words.
Ed
PS I use a bit of hylomar on the half shaft. I spoke to some of the silicon sealer people and their products aren't oil resistant.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version