Vehicle & Technical > Discovery

help advise needed (photo inside)

<< < (2/2)

Bobtail:
if it is the front one, you will also need the needle roller bearing that fits inside the stub axle that the drive shaft/cv joint runs in and they are very fine and a right bu££er to get out in one piece and undamaged

i got one from local stealers last july for about £40
but that was just the stub axle then you need

wheel bearings
tab washer
needle roller bearing
gasket

hope this helps a bit

Budgie:
The roller bearings were fitted to vehicles with chassis No: JA032850 onwards so Nick may not need them and he if he does then he can order FTC3154 which comes complete with the seal, bearing & bronze thrust washer already installed.  :wink:

nickW:
thanks for the help, i shall go and get the bits later

rollazuki:
Paddock.


Comes with the bronze bush already installed.....After Id carefully drifted them out in readiness.....

Navigation

[0] Message Index

[*] Previous page