Vehicle & Technical > Series Land Rovers
Wheel studs
barny:
Was a bit of a plonker at Great Brickhill on sunday, hadnt quite tightend the wheel nuts correctly and one of the wheels decided to fall off !
Have [!Expletive Deleted!] some studs and manage to thread some on the hub/flange. I've been told its possible to replace them with series 3 type ones, does any one know whats envolved in doing the conversion ?
dave_2A_2.25Turbo:
IRC you have to drill the holes slightly larger, then you can pull the new studs in with a wheel nut. If you do them all its 20 studs & 20 nuts to buy though.
There is a threadabout it somewhere.
barny:
£16 for the lot, didnt think that was too bad ! I'll have a quick looki one night this week and take some photos
barny:
Studs and nuts came today, just need to find a 15-16mm drill bit and a drill capable of holding/turning it :oops: !
Miniman:
This do ya mate.....
Navigation
[0] Message Index
[#] Next page
Go to full version