Vehicle & Technical > Discovery

yet more problems help

(1/2) > >>

landroverkeith:
Now i know this is a silly question but how can i test to see if my diff lock is actually engaging??

 I know it used to lock fine as i have used it on various trips.
But been out in car today trying to move it i noticed the lever doesnt seem to sit how i remember..... it engages low range very easly but i dont seem to be able to push it over to the left to lock the diff ive tried driving up and down the road in low and what i considered to be diff lock engaged but the dash light doesnt come on as normal and im certain the lever used to move further over..    :(

all in all am very seriously considering selling the money pit  :evil:  :(

MuddyMike:
To test if it is engaging just jack up one wheel, hand brake off, out of gear, with dif lock open it should turn, dif lock engaged and it should not. Its not uncommon for engaging dif lock to become difficult due to crap around, and corrosion on the linkage.

Mike

Badlad:
Easiest way I can think off is to engage it, jack up One wheel and leave gearbox in netural. Try and turn wheel :?

edit

beaten by two minutes lol :lol:

landroverkeith:

--- Quote from: "MuddyMike" --- Its not uncommon for engaging dif lock to become difficult due to crap around, and corrosion on the linkage.

Mike
--- End quote ---



ok thanks next question how do i remedy it ? without slinging more major cash at it

Badlad:
What I did was lifted the centre consol out, cut a small slice in the foam stuff that is held on with rivits just above the linkages and got loose with wd40, 3 in1 oil etc and gently persuaded it to work again. Dont think mine had been used in years :roll:

Navigation

[0] Message Index

[#] Next page