Vehicle & Technical > Defender

Calling all 110 owners.....

<< < (2/2)

Big Watty:
I have a 110 hard top and didn.t bother with the rear crossmember which if I remember correctly is there to support the CSW body work - I just attached the tree slider to the actual out rigger and have never had a problem

Jimbo:
OK, had a chance to compare BTM's pics (of a SW rear chassis outrigger) with my 110 (HT - no rear outrigger !), I can see what is not fitted to the hard top chassis, and it should be fairly straightforward to construct something - but looking at the first picture, it seems that the outrigger runs across the top of the main chassis member, is it one lump of box section that runs right across from one side to the other ?

Big Watty - I did consider just using the two mounting points for the sliders (A post to chassis bolt, and outrigger under drivers door), but as I plan to use the sliders to jack up the vehicle, thought it best to have substantial mounts at either end and in the middle - at the moment, only the front and middle of the slider would be fixed.

Jim

Navigation

[0] Message Index

[*] Previous page