Chat & Social > The Bar - General Chat

V8 exhaust question.

<< < (2/2)

Manicminer:
The Rover SD1 that I had years ago had for each manifold :- 4 into 2, 2 into 1 and then *both* outlet manifilds into 1.

rollazuki:
Ran my (tuned) v8 series with each side not connected together. Ran like a nail under 3000 rpm.
Ran fine flat out, but the 'Y' piece helps evacuate the other cylinders as each exhaust pulse passes thru it.
Keep the 'Y' piece, or run a connecting pipe between both branches.

mark.yellow.series.3:
thanks for the advise, any suggestions on the bore of the connecting pipe, or should it just be same diameter as rest of the exhaust.

Navigation

[0] Message Index

[*] Previous page