Vehicle & Technical > Discovery

great frustration !!!!!!!!!!!!!!!!!!!

(1/1)

chuggaman:
i finally got round to putting a lower ratio box in my disco....

while the gearbox was out i changed the cluth and fork and all the seals(great forsight i thought)

put it all back together and the results were better than expected...

pulls like a train.....all the backlash is gone........even the lockers are responding better in high...


then.........park it up............look underneath..........transfer box oil leaking.....

it seems i may have damaged the front oilseal that connects with the gearbox mainshaft whilst putting the transfer box back on...

any tricks for this guys..................or is it box off again????

Xtremeteam:
fill the drain hole full o sealer when u put the box's together  :wink:  :lol:

chuggaman:

--- Quote from: "RedlineMike" ---fill the drain hole full o sealer when u put the box's together  :wink:  :lol:
--- End quote ---



confused ?

drain hole ?

mike

Xtremeteam:
go underneath & look towards the back,behind the Gbox drain plug where the Gbox matesto the Tbox there is a circle,& if you were paying atention when u had the Tbox of theres a drain channel down from where the seal on the main shaft is,if u nick the seal it leaks down there & onto the floor,when you bolt them together its a good idea to put a dod of sealer in the channel so if it starts to leak it will contain the oil,

not the right way but it works

chuggaman:
nice one !!!!!!!

thanksmate


mike

Navigation

[0] Message Index