Vehicle & Technical > Defender

chequer

(1/2) > >>

timberdog:
what size drill bit for Chequer anyone advise?

wayneo:
5mm bigger than the rivit or bolt ur using, this helps lineing all the holes up

thumbs:
about half a mm biger than bolt or rivit in my view, gives a little clearence so you can line up and rivit or bolt a free fitting, but isnt like a stick in a bucket and the chequer could if bolts or rivits rattle loose slide all over the place

smo:
Its hardly rocket science, use the correct size drill for the fixings you are using, so if its an M5 bolt use a 5mm drill (or 6 tops) but dont oversize them by loads as itll be sloppy.

Simply place in position, mark one hole, drill and bolt this then proceed to drill and bolt the others in turn, no messing about and no chance of it not fitting!

wing nut:
use no more nails  :lol:  :lol:


 coat please :oops:  :oops:  :lol:

Navigation

[0] Message Index

[#] Next page