Vehicle & Technical > Discovery

rear halfshaft

(1/2) > >>

Mark2Disco:
i have undone the 5 bollts holding the halfshaft in
the axle
it will only move out about 50mm
then stops
do i need a slide hammer on it or am i not doing something
correctly
cheers
mark

simdeb:
Should come out ok , any reason for taking it out ?

is it front or rear ?

 :lol:

Mark2Disco:
oil seal is leaking and probably wheel bearing gone
but cant pull halfshaft out to get to wheel bearing and seal

Mark2Disco:
and its the rear

hobbit:
Make sure the vehicle brakes are off, after ensuring it wont roll anywhere, you dont have the diff lock in do you?

Also try pushing the end of the shaft down, it may be holding somewhere

Its probably just holding onto the diff, push it back and yank it a bit harder

Navigation

[0] Message Index

[#] Next page