Vehicle & Technical > Defender
'NAS' Lighting
Bush Tucker Man:
Jim.
How about this variation on the theme??
That'll make mine look pathetic on a gloomy night :roll:
Bush Tucker Man:
--- Quote from: "Jimbo" ---I measured up yesterday, a second reverse lamp and rear fog will fit - but I might have problems fitting the (planned) swing-away spare wheel carrier. As the swing-away is more important the the lights, I will purchase and fit the carrier and then see if the lamps will still fit.
--- End quote ---
Jim, also look at the carrier in the above link*
I've been to the 'Huddersfield Land Rover Centre' (see the 'I Want!, I Want!!' thread) & Simmonites looking at carriers
Both offered models lower mounts are sited in the reverse lens position.
The Piv-Lok (at 'HLRC') looks dare I say, too agricultural & archaic & you can't open the door from inside (not good on a Station wagon)
The Simmonites 'African Spec' lower bracket again covers the lens completely (don't know manufacturer)
I've been asking about this on LRnet, see if it'll open for you & have a read
* I've been told on LRnet (if it is the same carrier) that they're about £300 :shock:
Going to phone/e-mail over this matter later this morning, & will let you know the outcome
Jimbo:
Oooooo, I like the Frogs Island wheel carrier (don't like the price though :( )
Their place down in Didcot is within my work 'area' - perhaps I need to find an excuse for a trip down that way :wink:
suds:
try this option...
http://www.scorpionracing.co.uk/OFFROAD/Products%20images/cats/ext/rwc/rwc-HL-3.jpg
link from scorpion's site but shows their/wvh carrier and nas lights
Bush Tucker Man:
--- Quote from: "suds" ---try this option...
ink from scorpion's site but shows their/wvh carrier and nas lights
--- End quote ---
Thanks 'suds'
It does indeed look as though it clears the lights, & also allows the rear door to be opened from inside.
I'll 'speak' to them as well.
On enlarging the image & examining it. it appears that the mount fits just under the NAS lights & in-line with the bottom edge of the door.
I'll have to ask them for measurements to be sure
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version