Vehicle & Technical > Discovery

water pump

<< < (2/2)

hobbit:
Couple of methods

Try tightening slightly to see if the thread cracks off, then back and forth a bit at a time until it loosens off

Put some pressure on the bolt head with a spanner and then tap the end of the bolt with a hammer, the shock may release, then back and forward as above

Apply some heat to the bolt head, blow torch, etc, but remember ally will melt faster than the steel :wink:

Good luck!

extreme90:
have you still not done this little job yet  :lol:   i can nip over if you want on1 night if you need a hand, only live by port vale so only up the d road  :wink:

stratie:
I had the same problem, Then i got the mole grips out.
Job done  :wink:

Navigation

[0] Message Index

[*] Previous page