Vehicle & Technical > Series Land Rovers
Bad news
Miniman:
--- Quote from: "gtomo2" ---plus did you notice when we parked up the only two cars that struggled to get pass were both woman drivers :lol:
--- End quote ---
Sounds about right anyone would think they was driving blooming busses....he he
Dave:
No sorry mate never noticed :wink: shh :lol:
Dr Neil:
Dave, you'll have to give us a shout when you are doing it, if i'm not busy i'll give you a hand!! Can also get hold of a mig welder if Chris is in a good mood. Best thing to do is have a pre m.o.t or we can just have a hammer around and see what falls off :cry: :lol: :lol: :lol: ...
Is it the front to rear chassis you mean, and the bits near the spring mounts or is there more????
If your stuck for space we could maybe do it round my house by the garage? :wink:
Dave:
Thank Neil and everyone who has offered help make me very proud to be a member of this fantastic club
I have stripped some bits of it to have a better look had a mate have a look and it looks like we should be able to weld it to get another 12 months out of it.
I will try to get some pics and let you now how we get on. :wink:
denviks:
i bought my old disco a while back. she was in a bad way. the bloke i bought it from had put her in for an mot and it failed on lots of welding. he got a qoute from them and it was over £2500 worth :shock: . so i bought her off him and spent about 2 weeks bashing away to see what fell off or where the hammer would go through next. it was quite disheartning to be honest.
i spent the best part of 2 months welding her up, plating and replacing pannels , oh and teaching myself to weld in the prosses :oops: . all this was done in my dads front garden as i dont have anywhere to do it here. well she flew through her mot so all the hard work was worth it. i think all in all it cost me the grand total of about £300 for new pannels and material. keep at her mate and good luck........ :wink:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version