Vehicle & Technical > Range Rover

panhard rod

(1/1)

p4203:
morning all
 how easy is it to replace said bushes and where is the best place to get the poly ones   :?:

H:
Try Steve Parkers in Whitworth
www.steve-parker.co.uk
01706 854222


H

muddyweb:
Biggest problem is usually getting the old rubber ones out, as they have a tendency to get quite comfortable in there !

If you don't have a press to move them... the normal method is to burn out the rubber bit with a blow torch.. the centre tube and rubber should all come out.  (Don't breathe the smoke... it's nasty)

You will then be left with a tube in the panhard rod.   You can carefully cut this with a hacksaw or similar device.  Take the blade out, put it through the tube, and then reattach it to the saw.  Cut a slot in the tube, being careful not to but into the actual panhard rod.   This should give the tube sufficient slack to allow you to drive it out with a hammer / drift.

p4203:
cheers guys
 will do

Navigation

[0] Message Index