Vehicle & Technical > Series Land Rovers
The project rolls on !
Miniman:
Top stuff. I spent 3 days on the ramp welding my series 3 had to take rear tub floor out to weld tops and its just been the best. 12 months down the line and with a tap of the hammer it still sounds in tune..... you know that " TING " tune not the " THUD " Very nice job so far.. will be watching. When ya hoping to get it done buy or is work holding ya back like me...?
muddyweb:
--- Quote from: "Miniman" ---will be watching. When ya hoping to get it done buy or is work holding ya back like me...?
--- End quote ---
You just need to make sure you do all the welding *before* you do the Waxoyl.. else you make pretty little fires in the chassis rails :lol:
Work is always inconveniently taking up my time, but it's coming on. Not going to rush it to meet a deadline though... it needs to be right more than it needs to be quick.
I'd like to get it to the LRW show at Eastnor... so that gives me about 9 weeks to get it running !
Miniman:
Good luck. Like ya say do it right once and then ya can play in a motor you know and trust.
Tigger:
Making a bit more progress now....
Engine and gearbox in place too...
mark.yellow.series.3:
is that an original 101 bulk head?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version