Vehicle & Technical > Discovery

Clutch/Gearbox Woes

(1/4) > >>

Rangie3.0LtrDan:
OK, have had the clutch replaced (the full setup, cylinders, pipes, clutch, bearing, fork, bit the bearing slides along) and its still doing what it was doing before i had it done!!  Basically the clutch is really low, and crunching into 3rd gear and reverse!!

Have spent out £250 on this so far and would obviously like to get it sorted now!

Is it likely to be the gearbox, is it worth me having that replaced?

ChrisW:
Could be the damper? Round cylindrical thing just below the master cylinder on the bulkhead.
Could possibly be a dodgy pressure plate on the clutch too - had that happen to me before  :evil:

Rangie3.0LtrDan:
Its a fully brand new replaced clutch, no existing parts of the original clutch remain (apart from in the passenger footwell!).

ChrisW:
It was a fully brand new pressure plate too  :(
We took the damper out of circuit in case the diaphragm had gone and was taking up the fluid travel but it turned out to be the pressure plate.

Rangie3.0LtrDan:
But its doing it on both pressure plates, i think the pedal might need adjusting, a mate says you adjust the pedal on a series, why not on a disco?

Navigation

[0] Message Index

[#] Next page