Vehicle & Technical > Range Rover

New Toy - Roll Cage Completed

<< < (3/5) > >>

chris9119:

--- Quote from: "B@D@SS©®" ---What a superb job. What tubing did you use and what type of pipe bender.

Steve
--- End quote ---


tube was 45mm cold drawn seamless bent on a hydraulic bender. all joints were welded by a coded welder. some of the butt welds are invisable....

Chris

pedro:
That is one awsome looking cage.
Im currently building a bobbed rangie.
Im a bit unsure about the cill through the front wing.
Is the any chance you could give me advise on where the cage is mounted internally.
Cheers.

chris9119:

--- Quote from: "pedro" ---That is one awsome looking cage.
Im currently building a bobbed rangie.
Im a bit unsure about the cill through the front wing.
Is the any chance you could give me advise on where the cage is mounted internally.
Cheers.
--- End quote ---


Pedro, technically its an external cage, not internal.

The front/rear hoops are connected to the chasis. The front one comes down in front of the front door post (see picture), the rear one connects to the chasis just next to the body out rigger. This one comes through the floor (rear footwell).

If you need any more info, just ask.

Chris

PoPrivit:
Hi chap looks good. Im thinking of doing one this spring any chance of a pic of the roof and rear cab as this is the part im not sure about.

Cheers rich

barmiebrumie:
AAAARRRRHHH,  its just not fare every one is getting there trucks in order & i'm stuck rebuilding a house for my duaghter,

Looking nice there Cris, did you buy it readfy made or did you make it ??,




John.

Navigation

[0] Message Index

[#] Next page

[*] Previous page