Vehicle & Technical > Discovery

qt radius arms

(1/3) > >>

thumbs:
qt services radius arms

i now need these for my discovery after fitting more trick bits to the suspension,

been searching the web and found a site with a good price, but it asks whether you want 3 deg narrow or 3 deg wide, whats the difference and why? and what ones do i need?

cheers dont want to order the wrong ones!

defenderdan:
3 degree arms will correct a 2" lift ( they also do 6 degree for a 4" lift, and 0 degree  for standard) The wide or narrow bit refers to the width of the radius arm where the bush fits at the axle end. Later vehicles had wider arms than earlier vehicles. I think it changed with the 300tdi but i'm not definate on that. I would just measure the arms that are on your vehicle and give them the measurement, they should be able to sort you out. In reality it doesn't matter anyway, as long as you fit the apropriate bushes for the arms either will fit the vehicle as the axle mounts are the same. :)

defenderdan:
I would reccomend that you paint the arms before you fit them. They come gold passivated and they soon look crappy! :)

Range Rover Blues:
I'm told Defender are different to RRC/Disco, then agian early RRC are different too.. Ask Qt for advice, and buy direct it has to be the cheapest option.

thumbs:
ok, just browsinf for prices at the mo

if i have got lower turrets and shok mounts do i need 6 deg or is it just the spring height that makes a difference.

can you buy direct from qt?

Navigation

[0] Message Index

[#] Next page