Vehicle & Technical > Defender

Wheel Lockup

(1/3) > >>

Guy90:
I seem to have a small problem with the drum brakes on my 90. I have rebuilt everything from the stub axle onwards. There are new bearings, seals. New brake back plates, shoes, springs, wheel cylinders and drums. When all put back together with the wheel on, everything spins round fine. Put the wheel on and it still turns fine. Tighten the wheel nuts up and the whole thing locks solid. The wheel will not turn even with the brake shoes adjusted in as far as they will go.

Any ideas why this is happening?

Thanks.

Guy

karloss:
Are your drums and back plates the right ones? I.E. are they both for a 90? Do you have the same problem at both sides of the motor? Give us some more info. Someone on here will know. They always do!

Guy90:
The drums are definately for a 90. The back plates came from salvage but are identical to the ones I took off. I've done the same work on both sides and the other side is fine. The only diffrence is that the problem side doesn't have a brake drum screw (you can't buy them anymore). However I was told by numerous people this is not a problem.

Guy

Porny:
The lack of screw shouldn't cause any problems, however....

Please don't think I'm taking the micky, but are you doing the wheel nuts up correctly?  
Without the screw in the drum, if you are not doing the wheel up correctly, then the wheel 'may not' be going on square, thus resulting in the drum being slightly askew.  If that make sense.

See diagram.

Each wheel nut should be tightened in turn, and gradually, i.e. don't go round tightening each wheel nut to the required torque on the first pass.

Please, please don't think I'm taking the micky!!!
This problem is made worse with the use of an air gun.....  have seen it at work, exp by some of the trigger happy work experience kids (and apprentices)

Have you cleaned the mating surfaces, removing any traces of rust?  Ensuring that the drum can go on square.

Make sure you give the drum a couple of good wacks with a copper/plastic hammer when it's all back togther, ensuring that the shoes inside the drum seat/centralise correctly?

If the problem still persists, try swapping the drums over, if your sure everything else is correct.


Also, if you get some washers the thickness of the wheel, put these on after the drum and tighten the wheel nuts down onto them.  Saves having to keep lifting the wheel on and off while investigating.


Ian

Guy90:
Following Porny's instructions it all works perfectly :D  :D  :D . I had no idea there was specific way of doing up wheel nuts but doing Porny's way and then the way I've always done it, it does make all the diffrence. Because the drum was slightly loose with there being no drum screw then the wheel was not going on straight.

Thanks for the advice. Total lifesaver.

Guy

Navigation

[0] Message Index

[#] Next page