Vehicle & Technical > Discovery

td5 prop on 300tdi and front springs

(1/1)

ade666:
hi all again. i'm about to buy a td5 prop and flange from devon 4x4 and was wondering how hard it is to fit. the prop i can see is quite straight forward its the new flange that i'm un sure of. any help would be most welcom. also anyone bought springs from them, my old man emu fronts aren't upto the job(there 751's) i've seen 766 on Expedition Exchange but at £145 all in can i get some cheaper

Wanderer:
It's literally flange off flange on and fit the prop. Changing the flange is easier than doing the prop itself.

Range Rover Blues:
It's just a bit tight, handbrake and put it in 1st low box, you should be ok.  Check the condition of the output seal whilst you are there.

Navigation

[0] Message Index