Vehicle & Technical > Discovery
Southdown fitment
ChrisW:
I managed to fit the towing sockets onto the back door just between the number plate and spare wheel, it was a bit fiddly but the cabling does just fit inside the rubber flex from the body to the door :wink:
Damonski:
Both 12N and a 12S ? I also have my CB antenna going through there as my twig is mountedon the wheel carrier
My idea is to use a 13 pin euro socket under the rear wing covering the cable exit hole, then to use a 13pin euro plug with "flyleads" down to the normal 12N and 12S sockets mounted either side of the towbar. Our caravan doesnt have long N and S leads to reach anywhere else :(
I can also make up a 13pin euro to 12S flylead as I use the 12S socket for all my 12volt toys, like solding iron, lead light, compressor, etc etc because its live feed is taken from my split charged battery.
ChrisW:
Cabling for both N and the S through it, pulled a 12 core flex and a single core earth - very tight in the rubber sleeve though, you would probably struggle if you already have additional cabling in there.
I did have the sockets mounted on a T plate fitted to the bumper but it still got knocked about there!
colintandy:
:roll: ITS THE TWISTED PERFORMANCE TORNADO SPORTS EXHAUST SYSTEM AND YOUR RIGHT SHE DIESEL :wink:
Navigation
[0] Message Index
[*] Previous page
Go to full version