Vehicle & Technical > Discovery
Changing Brake Discs
davidlandy:
..an axle in afternoon, you must be paid by the hour!!!
hobbit:
--- Quote from: "Range Rover Blues" ---
Just a tip, drop the whole hub into the upturned roadwheel to hold it still as you remove/refit the disks. If they are rusted on you may have to cut them in half to get them off (the disks).
--- End quote ---
No seriously its one of the easier job, looks a lot but not that bad at all
This is what he means, even better if you have a stack of wheels :wink: :lol:
muddymart:
do you just finger tight the bearing nut up , or overtighten it, then slacken it back off?
hobbit:
Wind it up to take the slack out, then back off and set the end float
Henry Webster:
--- Quote from: "homer" ---
--- Quote from: "Henry Webster" ---Worth bearing in mind that the process is different on earlier (series1)discoverys
H
--- End quote ---
In what way? Mine is a '94 200TDi.
Cheers
Mark
--- End quote ---
Sorry to abandon you yesterday, was flat out and didn't have time for a full reply. Looks like you got the help that you required tho. Good old Mud-CLub! :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version