Vehicle & Technical > Defender

HELP!!! our '90 just died - 2.5 N/A engine

<< < (2/2)

karloss:

--- Quote from: "robbie" ---I tried turning the throttle back a little to slow it down which seemed to work but when we revved it, it tooks seconds for it to go back to idle.
--- End quote ---


Don't think that's the throttle you've adjusted there Rob. Not sure what it's called but I've played that trick before. Turn it back to where you got it from and you'll find the revs drop back normally. Don't have a piccie just now to describe it to you and the landy's miles away. Look around on top of the pump again and you will see the throttle stop screw.
HTH

Andy the Landy:

--- Quote from: "robbie" ---  I will be in the back
--- End quote ---
Where the kettle and choccy biccies are - top man 8)

Andy the Landy:
Is it running yet? Did you get the new lift pump? Give us a shout tomorrow night if you need a hand :D

robbie:
yeeh I got the new pump from Paddocks in the end. All of the units form A+J were the same in that I couldnt tighten the nut. The one from Paddocks is a 'conversion'.

It would have gone on today if the weather was a bit better. I had ot go and get my new wheels today from near Whitchurch so didnt get back til about 1.30ish. I couldnt be bothered getting wet by that time of day

Seeya tomorrow

Navigation

[0] Message Index

[*] Previous page