Vehicle & Technical > Discovery

slave cylinder replacement

<< < (3/4) > >>

Discotel:
Good News, I replaced the slave today and touch wood it seems to have cured the problem and the leak, it was a little tricky to do as there is a small inlet pipe to undo and move out the way but got there in the end, took around 1hr 30mins including bleeding so not bad really, will know tomoz for sure if the leak has stopped but looks good at the moment.

Also I took off the Panard rod the other day and it is a [!Expletive Deleted!] to get back on because I have fitted a 2' lift kit it will not line up on the drivers side as the longer springs force it down.

Is the only way to get it back on to remove the spring and jack up the axle to line it up...!..Any help here would save me some time and energy.

Terry

Richie_EB4:
I use a truck rachet strap to pull al back into line.

Xtremeteam:

--- Quote from: "Discotel" ---Good News, I replaced the slave today and touch wood it seems to have cured the problem and the leak, it was a little tricky to do as there is a small inlet pipe to undo and move out the way but got there in the end, took around 1hr 30mins including bleeding so not bad really, will know tomoz for sure if the leak has stopped but looks good at the moment.

Also I took off the Panard rod the other day and it is a !Expletive Deleted! to get back on because I have fitted a 2' lift kit it will not line up on the drivers side as the longer springs force it down.

Is the only way to get it back on to remove the spring and jack up the axle to line it up...!..Any help here would save me some time and energy.

Terry
--- End quote ---

i dont quite understand the problem,put the panhard rod in the hole on the axle & put the bolt through then get some1 tp push or pull the body to get the other hole to line up

Discotel:
The problem is the lift has forced the location bracket down about 3' and to the right so it does not line up with the bracket on the axle, I think I may have to take out the drivers side spring and ratchet strap it into place, or can it be done with the spring in situ.

Terry

Xtremeteam:
put the wheels back on & lower it down onto the ground so the vehicles weight is onit then try puting the panhard rod in

Navigation

[0] Message Index

[#] Next page

[*] Previous page