Chat & Social > The Bar - General Chat
one man brake bleeding
Bulli:
mighty-vac simply the best. Not cheap. You will struggle to get brake fluid flowing through small bore braided pipe without one.
You dont even need to pump the pedal! Simply squeeze the handle and it pulls the fluid through. Bought mine for bikes but took me about 15 mins to do when i changed to braided lines on the disco..about 40-50 quid but worth it if you do quite a bit. If you were nearer i would lend you it!
muddysteve:
well i've got myslf an eezibleed kit and the new caliper pistons and seals
wish me luck
Steve
V8MoneyPit:
I've never had any problem with the Land Rover manual method. Jar with clean fluid on the ground with a tube submerged from the bleed screw. Undo the screw. Push the pedal to the floor and pause for a couple of seconds and release. Pause a couple of seconds and push to the floor again.... and so on. The pause between strokes seem to be critical. Just pumping the pedal takes a lot more fluid. Just do this a few times for each corner and your done. Works first time, every time for me.
beast5680:
--- Quote from: "90HTDT" ---I found the eezibleed kit from halfrauds £15 excellent, i did me brakes with it and it was faultless!
--- End quote ---
I have just done mine this very lunch time with one of them :D
Rangie3.0LtrDan:
And how easy was it Beast?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version