Vehicle & Technical > Discovery

Continuing tyre saga

<< < (2/6) > >>

TimM:
Do the tyres fill the arches or do they STICK OUT, as I'm sure that the tyre must not protrude beyond the arch (or some similar wording) to be legal or MOTable.

Looking at your second picture it is probably a close call.

BigA:

--- Quote from: "paul_humphreys" ---
Whats the overall high of the tyers?

Paul
--- End quote ---


I will have to measure and let you know.


--- Quote from: "TimM" ---Do the tyres fill the arches or do they STICK OUT, as I'm sure that the tyre must not protrude beyond the arch (or some similar wording) to be legal or MOTable.

Looking at your second picture it is probably a close call.
--- End quote ---


Yes, depends on the angle  :lol: if you look dead down the side, they are about flush with the top of the arch, they don't protrude any more than they did on the 90 however.

davidlandy:
looks good to me. 8)

if it was mine i would lift it by 2".

dazzawhipple:
Andy

fit some wheel arch plastic bits, trim the wheel arch underneath nobody will see .....unless you run over someone  :twisted:

seriously they look good but trim very carefully, mark it out then bend it slowly Its aluminum It work hardens


Darren

BigA:

--- Quote from: "dazzawhipple" ---Andy

fit some wheel arch plastic bits, trim the wheel arch underneath nobody will see .....unless you run over someone  :twisted:

seriously they look good but trim very carefully, mark it out then bend it slowly Its aluminum It work hardens


Darren
--- End quote ---


Darren,

i may be popping round yours to do this..... could do with someone who has done it before looking over my shoulder taking sharp intakes of breath when i am about to do something wrong  :lol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page