Vehicle & Technical > Discovery

Alternator light flashing when on full lock

<< < (2/2)

fish:
Cheers guys, will check belt again, then pump pully. I hope it is only the belt!

Range Rover Blues:
It's the PAS pump belt, it may be greasy or worn, there may be wear in the sides of the pulley too that make it worse.  The PAS pump belt is very hard to get tight enough to stop this IMHO, I slacken the pulley bolts to alloy the pulley to slew, then tighten the pump adjusting bolts.  Tightening the pulley puts an extra bit of tension on the belts.  I have know people using a jack to tighten the belt :shock:

muddysteve:
the only way i could get it tight enough was to remove the alternator 1st the tighten it, then bolt the alternator back on  :roll:

Steve

Navigation

[0] Message Index

[*] Previous page