Vehicle & Technical > Discovery

Snorkel Hole cutter?

(1/4) > >>

BigA:
Hi all again, i seem to be posting new questions daily at the mo....  :?

Just received the new Safari Snorkel for the Disco, itching to fit, and wondered if anybody in the Northampton area had the hole cutter required that i could borrow, or any suggestions where i can get an 89mm hole cutter.

cheers

Andy

Jake:
I bought one for around £15.
I'm near Heathrow if you want to borrow it.
(but for the amount of fuel you could buy one  :wink: )
 :D

chuggaman:
why not just mark out the hole to be cut.

then drill lots of holes inside the line.

then cut between the holes like dot to dot!!

mike

Hightower:
Andy,

I have one but it's only a 70mm.  It was fine for when I did the Safari on my D2.  Is the D1 that different?

You're welcome to borrow it if you want.  Let me know.

BigA:

--- Quote from: "Hightower" ---Andy,

I have one but it's only a 70mm.  It was fine for when I did the Safari on my D2.  Is the D1 that different?

You're welcome to borrow it if you want.  Let me know.
--- End quote ---


I have been out today and could only find 70mm myself, instructions say 89mm (I have actually read them before the day i am fitting) but i will get the tape out and have a measure, if it looks OK i will give you a shout.

Cheers

Andy

Navigation

[0] Message Index

[#] Next page