Vehicle & Technical > Discovery

Safety Devices Roof Rack

<< < (3/3)

Bulli:
You want to try mine, its got too much suspension travel!!! I simply drilled and self tapped it in place. You need a few screws though!!

Dave:
Yes i put the highlift on the side so its easy to get of. pipe clamps did the job bolt them up work a treat.

Brains:

--- Quote from: "Bulli" ---Ive got a single piece of chequerplate 3mm ali . I cut it out so it slides past the front uprights bu about half an inch. Secured with self tappers. With a little crafty manipulation it follows the contours of the roof rack precisely.
--- End quote ---


looks good! :D  how much did it cost if you don't mind me asking?

Colin 009:

--- Quote from: "Bulli" ---Ive got a single piece of chequerplate 3mm ali . I cut it out so it slides past the front uprights bu about half an inch. Secured with self tappers. With a little crafty manipulation it follows the contours of the roof rack precisely.
--- End quote ---



That looks like a wicked paint job you have there, anychance of some other pictures. 8)

Bulli:
I bought a large sheet a few months back and have been slowly using it...its a big space that roofrack! about 50 quid i think

Navigation

[0] Message Index

[*] Previous page