Vehicle & Technical > Defender

Recovery Points

<< < (10/10)

bullfrog:
Better still a rachet spanner !
Yes you could cut off some of the "excess" first leaving enough to start the dye, Then cut a bit more and so on untill you have the amount threaded.
I take it the thread does not go upto the stop then as you could simply cut off the excess to do away with the spacer. You could just sleeve the extra bit and do away with the full width spacer.
Would still stick out that far but look neater.
Why not just cut and weld the hoop to the spare plate ?
Job done !

Navigation

[0] Message Index

[*] Previous page