Vehicle & Technical > Defender
300 TDi timing belt replacement
wing nut:
--- Quote from: "Paul" ---The fly wheel pin goes in the little hole in the bottom of the gearbox bell housing and locks the fly wheel. :wink:
--- End quote ---
:lol: your good :lol:
snezza69:
Any improvs for the other locking pins (an 8mm drill bit I can muster!
My Yorkshire tendancies are coming out!
I AM NOT ASHAMED.
Paul:
Your best off borrowing the proper kit if you can...
Alot can go wrong if it's not done right.
snezza69:
OK, makes sense, apart from Land Rover. Does anyone else do the kits? I wanted to get the job done this week before all the rad and intercooler go in!
Porny:
I've got the full Difflock kit - including the correct locking bar (better than using a breaker bar and the starter motor to undo the damper bolt)
Well worth the money!!!
Ian
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version